OSHA has no robot standard. These rules apply instead
OSHA says so on its own robotics page.1 Pick your situation to see the rule an inspector would look at.
General requirements for all machines
Guard the machine area so the operator and anyone nearby is protected from moving parts.
“One or more methods of machine guarding shall be provided to protect the operator and other employees in the machine area”Read it on osha.gov ↗
OSHA's robot guidance lives in its technical manual
Section IV, Chapter 4 of the OSHA Technical Manual covers industrial robot safety.2 It is guidance for inspectors and industry. It names eight sources of robot hazards.
- 01Integration or programming errors
- 02Control errors
- 03Unauthorized access
- 04Mechanical failures
- 05Time pressure
- 06Environmental sources
- 07Power system failures
- 08Improper assembly and installation
Hazard sources as named in the OSHA Technical Manual, Section IV, Chapter 4.
Engineering controls first. Lockout, procedures and gear after
The manual prefers guards and presence sensing over procedures and protective gear. It points to the lockout rule for any servicing.2
- Guards and sensing: fences, interlocked gates, light curtains, scanners.
- Limits: reduced teach speed and space limiting on the robot.
- Then: lockout, training, signs and protective gear.
OSHA's On-Site Consultation is free for smaller businesses
No cost to the employer.4
Confidential and separate from enforcement.
Run by state agencies or universities.
Request a visit on osha.gov ↗Insurance
An OSHA citation is rarely the only cost
Injured workers claim under workers' comp, and claims can reach the maker and the installer.
Questions buyers ask
No. OSHA's robotics page says there are no specific OSHA standards for the robotics industry. It applies its general rules, mainly machine guarding and lockout/tagout, plus the general duty clause.
R15.06 is not an OSHA rule. But OSHA lists it as an industry consensus standard, and a recognized hazard left uncontrolled can be cited under the general duty clause. Check with your assessor how your cell compares.
OSHA's lockout rule covers servicing and maintenance where an unexpected start could injure someone, including adjusting and setting up machines. Ask your assessor which jam-clearing tasks your procedure must cover.
OSHA's robotics pages list the 2012 edition. The current US edition is R15.06-2025.
Want an outside view before an inspector's?
Tell us the robot, the task and your state. We read every request and come back to you.
Sources (8), all read on 17 Nov 2026
- OSHA, Robotics (overview page)
- OSHA Technical Manual, Section IV Chapter 4: Industrial Robot Systems and Industrial Robot System Safety
- OSHA, Robotics: standards
- OSHA On-Site Consultation
- 29 CFR 1910.212, General requirements for all machines
- 29 CFR 1910.147, The control of hazardous energy (lockout/tagout)
- OSH Act of 1970, Section 5: Duties
- 29 CFR 1910.217, Mechanical power presses, paragraph (c)(3)(iii)(e)